Common Interface (For Model Dsb-B350T); Reset; Factory Default; Delete All Channel - Samsung DSB-B350S Instructions For Use Manual

OPERATING THE RECEIVER

4.4 Common Interface (for model DSB-B350T)

This STB has 2 slots of common interface for Viaccess, Conax,
Cryptoworks, Nagravision, Irdeto.

4.5 Reset

4.5.1 Factory Default

This is to restore the factory set values in case the user has
encountered some problems after changing any new values of
channel data and others, which may be in error. Select Factory
Default menu in Reset menu and press OK key. If you want to
continue, select confirm using BLUE( i ) key in the warning
window. The receiver will be reset to settings automatically.
Please note that the Factory Default procedure may take a
few seconds.

4.5.2 Delete All channel

In this option, your receiver delete the stored all channel.
Press OK key or key. At the request window, select "Yes" to
delete all channels or select "NO" to exit.

4.6 Change PIN Code

In this option, you need to enter the current PIN code at the
first cursor, and at the second cursor enter the desired
PIN code. To confirm, you need to enter the new PIN
code again.
Please remember the PIN code should be a 4 digit numerical
value.
THE FACTORY PRESET PIN Code : 0000
GB-32 D I G I T A L S A T E L L

TROUBLESHOOTING

Problem Possible cause
No display LED on Power cord
the front panel; not plugged in correctly
No power supply
No pictures on the screen Receiver in Standby mode;
Scart not connected tightly to video
output of television; incorrect channel
or video output selected on television.
No sound Audio cord connected incorrectly;
Loudness level = 0;
Muting active
Remote Control does not Incorrect operation;
operate directly
Batteries dead or inserted incorrectly
Poor picture quality signal Signal strength to lowa
strength in
On-Screen Error Message Antenna cable not connected
"Searching for signal" or not tight;
LNB defective;
Incorrect position of the
satellite antenna;
LNB is set to "OFF" in LNB
Setting menu
On-Screen Error Message Satellite not yet set
"No Channel"
On-Screen Error Message: Smart card:
"Please check the smart card"; -not plugged in correctly;
"Please insert the Smart card" -not plugged in.

DISPOSAL

The device, packaging material (e.g. Styrofoam) and the batteries must never be disposed
of with household refuse. Please obtain appropriate information about the regulations in your
community, and dispose of all refuse in accordance with regulations at the separate
locations provided.
I T E R E C E I V E R
Solution of the problem
Power cord plug in correctly
Set Receiver to "ON";
Check connection and correct;
Check channel and video output and
correct (TV instruction manual)
Check connection and correct;
Increase loudness on television set;
Press the MUTE key
Point remote control toward the Receiver.
Replace batteries or insert correctly
Check all wire connections. Check the
"Automatic channel search" menu, correct
alignment of your antenna
Check connection and correct;
Change LNB;
Check position and correct,
Check the signal strength in the "Automatic
channel search" menu
Scan of in "Automatic channel search " or
"Manual channel search" menu
(depend on model)
Check the Smart card.
"insert the Smart card"
GB-33