ADJUSTING THE LABEL SENSOR
The "Se" printers can position labels using either a label gap (transmissive) or an
Eye-Mark (reflective) sensor. The sensor used is selected by DSW2-2. The gap sensor
position can be adjusted over a limited range. In addition, the signals from the
sensors can be adjusted using the LCD panel to compensate for different liner
opacities and/or Eye-Mark reflectance values.
Max Label Width
(includes liner)
Max Print Width
Gap Sensor
Adjustment Range
Non-Print Area
SATO "Se" Print Engines
Gap Sensor Adjustment
Non-Printable Area
Eye-Mark on Back Side of Liner
Minimum Width = 0.125" (3 mm)
Minimum Length = 0.5" (12 mm)
M-8459Se
M-8460Se
5.27" (134 mm)
6.5" (165 mm)
4.4" (112 mm)
6.0" (152 mm)
0.5" to 2.67"
0.5" to 3.25"
14 mm to 68 mm
14 mm to 82 mm
0.12" (3 mm)
0.12" or 0.25"
3 mm or 6.5 mm
PN 9001073 Rev C
Print Head
Maximum Width
Maximum Print Width
M-8485Se
5.27" (134 mm)
5.0" (128 mm)
0.5" to 2.67"
14 mm to 68 mm
0.12" (3 mm)
Section 2. Installation
M-8490Se
5.27" (134 mm)
4.4" (112 mm)
0.5" to 2.67"
14 mm to 68 mm)
0.12" (3 mm)
Page 2-9