Download User Defined Protocol Codes - SATO M-8485Se Operator And Technical Reference Manual

Section 3. Configuration

DOWNLOAD USER DEFINED PROTOCOL CODES

The user can define a set of custom protocol codes and download them to the printer
using the <ESC>LD command.
V 05.00.03.00
INITIALIZING
USER DOWNLOAD
PRESS THE LINE KEY
USER DOWNLOAD
WAITING
Page 3-26
Displays the firmware during the initialization.
To enter the User Download mode, DSW2-7 is placed in the
on position and the printer is powered on while simultaneously
pressing the LINE key. The printer will emit one long beep
after which the LINE key is released.
1. Set DSW2-7 Off to replace the Standard protocol codes or
On to replace the Alternate set of protocol codes.
2. Press the LINE key. The printer is now waiting for the data
to be sent.
3. Transmit the download data command stream to the printer.
4. After the data has been received, the printer will beep and
print a status label. If it does not beep and print a status
label, the printer did not accept the data.
5. If the printer did not beep and print a status label, turn the
printer off and check your data stream for errors and start
the download process over.
6. If the custom codes are correct, press the FEED key to
accept them and terminate the download process. If they
are incorrect, turn the printer off without pressing the FEED
key and begin the process again.
9001073 Rev C
SATO "Se" Print Engines