Roland UM-3EX Owner's Manual page 16

3. Click the Hardware tab, then click [Driver Signing].
The Driver Signing Options dialog box will open.
4. In the Driver Signing Options dialog box, select "Ignore," then click [OK].
If the current setting is "Warn" or "Block," change this to "Ignore." Then, when you've finished
installing the driver, change it back to the original setting.
5. Click [OK] to close the System Properties dialog box.
6. Exit all currently running software (applications).
Also close any currently open windows. If you are using virus checking or similar software, you must
exit all of these programs as well.
7. Prepare the CD-ROM.
Insert the CD-ROM into your computer's CD-ROM drive.
* If the message "Windows can perform the same action each time you insert a disk or connect a
device with this kind of file" appears, [Cancel].
8. From the Windows start menu, choose Run....
9. In the Open field of the Run... dialog box, type the following and click [OK].
D: \Driver\XP2k\Setup.exe
* The drive name is D: in the example shown here, but may be different on your system. Use the drive name for
your CD-ROM drive.
10. The Driver Setup dialog box will appear.
Click [Next].
11. To begin the installation, click [Next] once again. Installation will begin.
Windows XP users:
If "Driver Signing Options" in step 4 is set to anything other than "Ignore," a dialog box with an
"!" or "x" symbol will appear. If a [Continue Anyway] button is displayed, click [Continue
Anyway] to proceed with the installation. If you are unable to continue, click [OK] and repeat the
driver installation from step 1.
Windows 2000 users:
If "Driver Signing Options" in step 4 is set to anything other than "Ignore," a dialog box
indicating "Digital Signature Not Found" will appear. If a [Yes] button is displayed, click [Yes]
to proceed with the installation. If you are unable to continue, click [OK] and repeat the driver
installation from step 1.
The "Setup is now ready to install the drivers" dialog box will appear.
16