Removing The Memory; Checking That Memory Is Installed Correctly - Roland Fantom XR Owner's Manual

Removing the Memory

To remove the memory module, reverse the installation procedure.
1.
Simultaneously press outward the white clips located at
either end of the socket.
fig.31-006
2.
Remove the memory module from the socket.
Expanding the Memory
Checking that memory is
installed correctly
1.
Turn on the power, as described in "Turning On the Power"
(p. 17).
2.
Press [MENU].
The Top Menu screen will appear.
3.
Press or to select "System."
4.
Press [ENTER].
5.
Press or to display System Memory Info screen.
Verify that the screen correctly shows the amount of memory
you installed.
fig.31-007
6.
Press [EXIT] to exit the System screen.
If the correct amount of memory is not shown, it is possible that
the memory is not being recognized properly. Turn off the
power as described in "Turning Off the Power" (p. 19), and re-
install the memory correctly.
Specifications of the expansion memory
(DIMM) that can be used
Number of pins: 168-pin
Speed: 100 MHz (PC100 CL=2)
133 MHz (PC133 CL=3)
Voltage: 3.3 V
Capacity: 64/128/256/512 MB
Board height: 38 mm or less
The Fantom-XR has been confirmed to work with standard
memory that meets the above specifications. However, we
cannot guarantee that all memory of these specifications will
work correctly. Please be aware that even with identical
specifications, differences in the design of the memory module
or the conditions of use may mean that a memory module may
not be usable.
171