Printronix L5520 User Manual page 114

Chapter 3
Loading Flash Memory
FILE SYS INVALID
OPTIMIZE&REBOOT
FILE SYS WRITE
CHECK FLASH
INSUFFICIENT RAM
REBOOT/ADD RAM
LOADING FONTS
114
Table 2. Flash Messages
The flash file system is either
invalid (corrupt) or not present.
The cause can be either a
program error or a hardware
failure of the DC flash memory.
One or more errors occurred
while the printer was writing a
file into the flash file system.
The printer has marked the
corrupt file for deletion. The
cause can be data that became
corrupted during download, or a
hardware failure of the DC flash
memory.
NOTE: Although the corrupt file
cannot be used, it still
occupies space in the
flash file system. To
free this space,
optimize the flash file
system.
Before the printer can write a
file into the flash file system, the
file must be completely stored
in the DC DRAM. In certain
situations, there might be
insufficient DRAM space for the
file, especially when the printer
has been operating for some
time.
The printer is copying fonts
from DC flash memory to DC
DRAM.
Reboot the printer
several times. If the
message persists,
replace the DC flash
memory on the
controller board, or
contact your service
provider.
Optimize the flash file
system to delete any
marked files, then retry
the operation. (If you
were downloading
software, optimize the
flash file system, then
power off the printer and
download the software
again.)
If the message persists
after several tries,
contact your service
provider.
Reboot the printer to
clear the DC DRAM. If
the message persists,
contact your service
provider.
None.