Printronix L5520 User Manual page 105

8. Connect a parallel data cable to the default parallel port (LPT1)
of an IBM-compatible computer that is using the PC-DOS or
MS-DOS operating system.
NOTE: You can connect the cable to the LPT2 port if the LPT1 port
is already in use. If you use the LPT2 port, the download
command is different, as described in the note after
step 33.
9. Connect the parallel data cable to the parallel port of the
printer.
10. Plug the printer AC power plug into its electrical outlet.
11. Power on the computer.
12. Set the printer power switch to | (On).
13. If you have no emulation software to install and you are
installing only logo, form, TIFF, setup, or font files, skip to
step 37. If you do have emulation software to install, continue
with step 14.
14. Set the printer power switch to O (Off).
15. If the emulation you are installing is supplied on a single
diskette, skip to step 28. If the emulation is supplied on two or
more diskettes, you must first recombine the multiple files from
the diskettes into one file on your computer's hard drive;
continue with step 16.
16. Create a directory on your computer hard drive where you will
store the recombined files from the emulation diskettes by
typing the following at the DOS prompt:
MD DOWNLOAD <Return>
17. Make the newly-created directory the "active" directory by
typing the following at the DOS prompt:
CD DOWNLOAD <Return>
18. Insert the last emulation diskette in the series (e.g., 2 of 2, 3 of
3, etc.) into diskette drive A (or B) of the computer.
Downloading Into Flash Memory
105