G-Link™ Connection - Pioneer PRO-1130HD Operating Instructions Manual

Enjoying through External Equipment
G-LINK™ connection
You need to make this connection, so that the TV Guide On
Screen™ system works with your cable box to receive program
listings or to enable the system's recording features with your
VCR.
When connecting both the cable box and VCR
G-LINK cable (supplied)
Point to the remote
control sensor
Media Receiver (rear view)
MONITOR
OUT
INPUT 2
ANT B
I N OUT IN
SERVICE ONLY
CONTROL
AV cable (commercially available)
G-LINK cable's wand
VCR
NOTE
• In order to use your cable box or VCR with the TV Guide On
Screen™ system, you have to correctly set up for the TV
Guide On Screen™ system. See "TV Guide On Screen™
System Setup" on page 31.
• Make sure to position the G-LINK cable's wand so that its
light emitting section faces the remote control sensor on the
cable box or VCR.
• Make sure to place the VCR into the standby status when
presetting TV programs for recording with the TV Guide On
Screen™ system.
• Be careful not to leave the cable looped when making the
connection.
• If degraded picture quality is observed while viewing copy-
protected VOD movies connect the Media Receiver directly
to other TV sets. Do not connect through a VCR.
• Use only one wand on the G-LINK cable to control one
device.
S400
G-LINK
ANT/ (TS)
OPTICAL
Cable CAR
CABLE A IN
DIGITAL OUT
R-AUDIO-L
SUB WOOFER
INPUT 3
Y C B / P B C R / P R
R-AUDIO-L VIDEO S-VIDEO INPUT 1 INPUT 3
COMPONENT
INPUT 1 HDMI
VIDEO
AV cable (commercially
available)
Cable box
G-LINK cable's wand
Point to the remote
control sensor
12
77
En