Preventing The Plasma Display From Falling Over - Pioneer PRO-1130HD Operating Instructions Manual

Preparation
05

Preventing the Plasma Display from Falling Over

After installing the stand, be sure to take special care to ensure that the Plasma Display will not fall over.
Stabilizing on a table or floor
Stabilize the Plasma Display as shown in the diagram using
screws that are available on the market.
NOTE
To stabilize the Plasma Display on a table or on the floor, use
screws that have a nominal diameter of 6 mm (1/4 inch) and
that are at least 20 mm (13/16 inch) long.
CAUTION
A table or an area of the floor with adequate strength should
always be used to support the Plasma Display. Failure to do so
could result in personal injury and physical damage.
When installing the Plasma Display, please take the necessary
safety measures to prevent it from falling or overturning in case
of emergencies, such as earthquakes, or of accidents.
If you do not take these precautions, the Plasma Display could
fall down and cause injury.
The screws, hooks, chains and other fittings that you use to
secure the Plasma Display to prevent it from overturning will
vary according to the composition and thickness of the surface
to which it will be attached.
Select the appropriate screws, hooks, chains, and other fittings
after first inspecting the surface carefully to determine its
thickness and composition and after consulting a professional
installer if necessary.
18
En
Using a wall for stabilization
1. Attach fall-prevention bolts (hooks) to the
2. Use strong cords or chains to stabilize it
• Perform this work in the same way on the left and right sides.
Use hooks, ropes, chains, and fittings that are available on the
market.
Recommended hook: Nominal diameter 8 mm (3/8 inch)
20 mm min.
Length 12 to 15 mm (1/2 to 5/8 inch)
(13/16 inch min.)
Plasma Display.
appropriately and firmly to a wall, pillar, or
other sturdy element.
NOTE
1 Hook
2 Cord or chain
Fitting
12 to 15 mm
(1/2 to 5/8 inch)