Computer Compatibility Chart; G-Link™ Connection - Pioneer Elite PRO-1140HD Operating Instructions Manual

Using External Equipment

Computer compatibility chart

Resolution Frequency
720 × 400
70 Hz
640 × 480
60 Hz
72 Hz
75 Hz
800 × 600
56 Hz
60 Hz
72 Hz
75 Hz
1024 × 768
60 Hz
70 Hz
75 Hz
1360 x 768 60 Hz
G-LINK™ connection
To record with a VCR through the TV Guide On Screen™
system, connect the VCR to the panel using the G-LINK cable.
NOTE
• In order to use a VCR with the TV Guide On Screen™ system,
confirm the factors listed below. See "TV Guide On Screen™
System Setup" on page 32.
• The G-LINK cable's wand must be positioned so that its light
emitting section faces the VCR's remote control sensor.
• The VCR is in Standby when selecting TV programs to record
using the TV Guide On Screen™ system.
• Avoid the cable loops when making the connection.
Attaching the ferrite core
To help prevent noise, attach the supplied ferrite core to the
connector end of the G-LINK cable as shown.
Ferrite core
CAUTION
• Regarding the G-LINK cable, attach the supplied ferrite core.
If you do not do this, this Plasma Display will not conform to
mandatory FCC standards.
When connecting the VCR
Plasma Display (rear view)
Ferrite core
G-LINK cable (supplied)
AV cable (sold
separately)
VCR
G-LINK cable
Pull the cable slightly to
take up any slack A.
A
As close as possible
Viewed from the bottom
of the Plasma Display
G-LINK cable's wand
Point to the remote
control sensor
12
73
En