Pioneer Elite PRO-110FD Operating Instructions Manual page 21

Preparation
2 Screw a supplied screw into the speaker
mounting hole (lower of the two) at the top,
rear of the display.
• Do not tighten it all the way yet. Leave it loose, with about
5 mm left to tighten.
Speaker
mounting
hole
Top of display
Leave a space of about 5 mm
3 Hang the speaker mounting fitting on the
screw you installed at the top by passing the
wide part over it and lowering into the slot;
screw in the lower screw temporarily.
After passing the wide part of the hole of the speaker
mounting fitting (top) over the screw, lower the speaker onto
it.
After passing the
wide part of hole
over the screw, lower
the speaker.
Tighten with the
provided screw the
bottom speaker
mounting fitting to the
display temporarily
(one place bottom).
4 Adjust the position of the speaker and then
tighten the upper and lower screws firmly.
5
Top, rear of
display
5 mm
6
7
8
9
Tighten the two screws, at the top and
bottom for each speaker (total of four
screws), thus fixing the speakers to the
display.
Pass the supplied speaker cable between the
speaker and the plasma display (below the
speaker mounting fitting) from below.
Connect the speaker cables to the speaker
(see next page).
Insert the cable in the groove on the speaker.
Speaker cable
Connect the other end of the speaker cables
to the rear of plasma display (see next page).
Speaker terminal
Insertion in
groove
05
21
En