Preparation; Installing The Plasma Display; Moving The Plasma Display; Attaching The Pioneer Stand - Pioneer Elite PRO-110FD Operating Instructions Manual

Preparation

Chapter 5
Preparation

Installing the plasma display

Over 50 cm
(19-11/16 inches)
Over
10 cm
(3-5/16
inches)
Location
• Avoid direct sunlight. Maintain adequate ventilation.
Note
• Allow enough space around the upper and back parts when
installing to ensure adequate ventilation of the rear of the unit.

Moving the plasma display

Because the plasma display is heavy, be sure to have someone
help you when moving it.
(PRO-150FD)
(PRO-110FD)
Caution
When installing on a rack, etc., hold the plasma display.

Attaching the Pioneer stand

The plasma display comes with the Pioneer table top stand. You
can also install the display on a rack by detaching the stand. The
method for attaching/detaching the stand varies depending on
the product.
Caution
• This product can be used only with the attached stand. Using
other stands can result in instability, possibly causing injury.
• The weight of a 60 inch plasma display is about 55.5 kg (122.4
lbs.) and a 50 inch about 38.8 kg (85.5 lbs.), it has no depth, and
is unstable. Therefore, at least two people must assemble and
install it.
Assembling the stand (PRO-150FD only)
1 Turn the base cover over so the underside is
facing up.
2 Insert the stand pipes into the base cover.
Insert stand pipe (R) into the side marked "R" and stand pipe
(L) into the side marked "L".
3 Tighten the screws 1 (M5 x 10 mm: black) to
stabilize the stand pipes.
➀
Screws
(M5 x 10 mm: black)
Stand
pipe with "R"
inscribed
Completed
Table top stand
Front
Note
• Assemble the stand with a soft sheet placed under the base
cover. If a sheet is not laid before assembly, the front surface of
the base cover may be scratched.
• Please take care when installing stand pipes (L) and (R) to
ensure that they are in the correct positions. Mistakenly
installing the stand pipes may damage the stand.
➀
Screws
(M5 x 10 mm: black)
Rear
Stand
pipe with "L"
inscribed
Base cover
Sheet
05
17
En