Watching Tv Channels; Selecting The Antenna; Changing Channels - Pioneer PDP-4360HD Operating Instructions Manual

Plasma display system
Hide thumbs Also See for PDP-4360HD:
Table of Contents

Advertisement

Available languages

Available languages

Basic Operations
06

Watching TV channels

Unless you set up TV channels that you can watch under the
current conditions, you cannot tune in those channels. For the
procedure, see "Setting up TV channels" on page 38.
NOTE
• When watching a digital TV program, you may see
emergency alert messages scrolling at the top of the screen.
Those messages are broadcasted by TV stations as
necessary when in emergency situations.

Selecting the antenna

After confirming that the Mode switch on the remote control
unit has been set to "TV", press ANT on the remote control unit
to select antenna A or B.
• Make this selection depending on the connections to the
antenna input terminals on the Media Receiver (page 20).

Changing channels

To increase the channel number, press CH + on the remote
control unit. To decrease the channel number, press CH –.
• CHANNEL UP/DOWN on the Media Receiver operates the
same as CH +/– on the remote control unit.
• Press CH RETURN to switch the currently tuned channel to
the previously tuned channel.
Press CH RETURN again to restore the currently tuned
channel.
Using 0 – 9 and • (dot) on the remote control unit
Select channels directly by pressing buttons 0 to 9. To select
subchannels, also use the • (dot) button.
EXAMPLE
• To select channel 5 (1-digit channel), press 5.
• To select channel 25 (2-digit channel), press 2 then 5.
• To select channel 125 (3-digit channel), press 1, 2, then 5.
• To select subchannel 10.01, press 1, 0, • (dot), 0, then 1.
• To select subchannel 10.001 (for cable TV), press 1, 0,
• (dot), 0, 0, then 1.
NOTE
• After entering a channel or subchannel number, you may
press CH ENTER to tune in the channel more quickly.
• Each time you change a channel, a channel banner appears
that shows information about the currently selected
channel. To clear the channel banner, press INFO.
• If you do not setup the TV Guide On Screen™ system, the
channel banner may not display certain types of program
information.
26
En
Media Receiver
(front view)
REC
ON
STANDBY
TIMER
TV GUIDE
STANDBY/ON
ENTER
DOWN
UP
LEFT
RIGHT
INPUT
DOWN
UP
DOWN
UP
VOLUME
CHANNEL
CHANNEL UP/DOWN
Channel banner
12:33pm
DTV 2 • 1002.102 A
XXXXXXXXXX
XXX
12:30pm — 2:00pm

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pdp-5060hdPdp-506puPdp-r06uPdp-436pu

Table of Contents