Connections; Easy Connections - Pioneer DV-610 Operating Instructions Manual

Chapter 2
02

Connections

Easy connections

Important
• Before making or changing any connections, switch off the power and disconnect the power
cable from the AC outlet.
• The setup described here is a basic setup that allows you to play discs using just the cables
supplied with the player. In this setup, stereo audio is played through the speakers in your TV.
• This player is equipped with copy protection technology. Do not connect this player to your
TV via a VCR using audio/video cables, as the picture from this player will not appear properly
on your TV. (This player may also not be compatible with some combination TV/VCRs for the
same reason; refer to the manufacturer for more information.)
TV
P
B
P
R
HDMI OUT COMPONENT VIDEO OUT
1 Connect the VIDEO OUT and
AUDIO OUT L/R jacks to a set of A/V inputs
on your TV.
Use the supplied audio/video cable,
connecting the red and white plugs to the
audio outputs and the yellow plug to the video
output. Make sure you match up the left and
right audio outputs with their corresponding
inputs for correct stereo sound.
See below if you want to use a component,
S-Video or SCART cable for the video
connection.
10
En
To audio/video inputs
White
VIDEO OUT SL C L
Y SR SW R
S-VIDEO OUT AUDIO OUT (5.1ch)
Yellow
Red
AV CONNECTOR (RGB) TV/AV Receiver
To power outlet
2 Connect the supplied AC power cable
to the AC IN inlet, then plug into a power
outlet.
Note
• Before unplugging the player from the
power outlet, make sure you first switch it
into standby using either the front panel
 STANDBY/ON button, or the remote
control, and wait of the
disappear from the player's display.
• For the above reasons, do not plug this
player into a switched power supply found
on some amplifiers and AV receivers.
AC IN
OPTICAL COAXIAL
DIGITAL AUDIO OUT
message to
-OFF-