Pepperl+Fuchs VisuNet GMP Series Hardware Manual page 6

VisuNet GMP DM
Safety
1.4 Pertinent Laws, Standards, Directives, and further Documentation
Observe directives, standards, and national laws applicable to the intended use
and the operating location. Observe Directive 1999/92/EC in relation to hazardous areas.
The corresponding datasheets, manuals, declarations of conformity, EU-type
examination certificates, certificates, and control drawings if applicable (see datasheet)
are an integral part of this document. You can find this information under www.pepperl-
fuchs.com.
Due to constant revisions, documentation is subject to permanent change. Please refer only to
the most up-to-date version, which can be found under www.pepperl-fuchs.com.
1.5 Intended use
The device is only approved for appropriate and intended use. Ignoring these instructions
will void any warranty and absolve the manufacturer from any liability.
The device must not be repaired, changed, or manipulated. In case of failure, always replace
the device with an original device.
1.6 Installation and commissioning
The device must only be operated in the specified ambient temperature range and at the spec-
ified relative humidity without condensation.
Use shielded cable
To connect interfaces only use shielded cable.
Screwing/locking connectors
To advance the cable shield screw/lock the connectors.
The device must be disconnected from the power supply prior to installation and maintenance.
The power supply may be activated only after all the circuits required for operation have been
fully assembled and connected.
Leading of data cables and power circuit lines
Lead data cable and power circuit line in separate cable channels.
Check cables and connectors
Before commissioning the system check all cables and connectors.
6