Cam Orientation; Rose Installation - Assa Abloy Corbin Russwin CL3100 Series Installation Instructions Manual

CL3100 Series
Grade 1 Key-In-Lever VR Lever Lock
Installation Instructions
7

Cam Orientation

1. Lock lever by button, if applicable.
2. Turn slotted cam until lever catch button can be deprssed.
8

Rose Installation

D Rose
1. Orient cam and depress lever catch button (see cam orientation diagram page 7 step 7). The lever catch button will slide
into the lever catch slot in the cam. Use the rose installation tool (RIT) to retain the lever catch button - see below for RIT
instructions (for D rose installation only). Lock lever by button, if applicable.
2. Install rose support plate. Note the flange orientation and door prep.
3. Install rose support plate collar and tighten with CL3100 wrench.
4. Install rose onto support plate.
C, E and K Rose
2A. Install C, E or K rose.
Note the flange and
bearing operation.
3A. Install rosette and tighten
with the CL3100 wrench.
CAUTION
If excessive wrench torque
is required, stop and check
for cross-threading.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2016, 2019, 2024, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights
reserved. Reproduction in whole or in part without the express written permission of ASSA ABLOY
Access and Egress Hardware Group, Inc. is prohibited.
Slotted cam orientation:
Standard cylinder
Lever catch slot
Lever catch slot
Lever catch
Lever catch
button
button
Tailpiece slot
Tailpiece slot
Inside
A. depress lever
catch button
B. capture lever
catch button
Slotted cam orientation:
IC cylinder
C,E and K rose installation
3A rosette
2A rose
bearing assembly
2 rose
support
plate
D rose installation
7
Lever catch slot
Lever catch slot
Lever catch Lever cat
Lever catch
button
button
Tailpiece slot
Tailpiece slot
1 lever catch button
3 tighten rose
support plate
Outside
4 rose
1 rose
installation
tool
FM345 06/24