Network Camera Cabling - Panasonic KX-HCM230 Operating Instructions Manual

4.1.1 Network Camera Cabling

Check the location where Network Camera should be installed. Select the proper
cable suited to Network Camera location. Consult an authorized wiring electrician
for cabling.
1.
Put the cables through the Connector Cover (1.). Connect the DC plug of the
AC adaptor to the DC IN jack (2.) and Category 5 straight/cross cable to the
Ethernet port (3.). Connect the AC plug of the AC adaptor to the power outlet
(4.).
DC IN
jack
Ethernet
port
Notes
• Mounting and cabling instructions described in this Operating
Instructions follow generally accepted guidelines suitable for residential
installations. In some areas, commercial and industrial installations are
regulated by local or state ordinances. For such installations, contact
your local building department or building inspector for more details.
• External I/O and Ground should be threaded through Connector Cover.
Once you putty the cables, External I/O and Ground cannot be
connected until you take the putty off.
• Check the location of Network Camera, the type and the length of the
Ethernet cable (Max. 100 m [330 feet]). Use an Ethernet cable as short
as possible for outdoor use. Lightning may cause serious damage to
Network Camera or the connected devices.
• Use a category 5 cross cable when connecting directly to a PC.
(2.)
DC Plug
(3.)
Category 5 straight/cross cable
[For assistance, please call: 1-800-272-7033]
Operating Instructions
(4.)
AC adaptor
Connector
Cover
(1.)
To Network
Power
Outlet
93