How To Turn On Network Camera For Installation - Panasonic KX-HCM230 Operating Instructions Manual

Operating Instructions
2.3 How to turn on Network Camera for
Installation
Connect the DC plug of the AC adaptor to the DC IN jack and a category 5 straight/
cross cable to the Ethernet port. Connect the AC plug of the AC adaptor to the
power outlet to turn on Network Camera. Pan/Tilt moves to the center position.
DC IN
jack
Ethernet
port
Notes
• AC adaptor is used as the main disconnect device, so ensure that the
power outlet is located/installed near the equipment and is easily
accessible.
• Use only the specified Panasonic AC adaptor PSLP1233 (Order No.
PSLP1233Z).
• When you set up Network Camera in [Type 3], connect it temporarily in
[Type 1], [Type 2] or [Type 4].
• When Indicator is orange, confirm that the Ethernet cable is properly
connected, or PC, Ethernet hub or broadband router is properly working.
20
DC Plug
Category 5 straight/cross cable
AC adaptor
To Network
Power
Outlet