[Position] Menu; [Shift]; [Aspect] - Panasonic PT-DW730ULS Operating Instructions Manual

[POSITION] menu

[POSITION] menu
Select [POSITION] from the main menu, and
select the item from the sub-menu.
Refer to "Navigating through the menu"
( page 41) regarding the operation of the menu

screen.
z After selecting the item, press

[SHIFT]

You can move the image position vertically or
horizontally if the image position projected on the
screen is shifted even when the relative position of the
projector and the screen is installed correctly.
1) Press ▲▼ to select [SHIFT].
2) Press the <ENTER> button.
z The [SHIFT] screen is displayed.
3) Press ▲▼◀▶ to adjust the position.
■ For vertical (up and down)
adjustment
Operation
The picture
Press . position moves
up.
The picture
Press . position moves
down.
■ For horizontal (right and left)
adjustment
Operation
The picture
Press . position moves to
the right.
The picture
Press . position moves to
the left.
48 - ENGLISH
to set.
Adjustment
Adjustment

[ASPECT]

You can switch the aspect ratio of the image.
The aspect ratio is switched within the screen range
selected in [SCREEN SETTING]. Set [SCREEN
SETTING] first. ( page 57)

1) Press ▲▼ to select [ASPECT].
2) Press ◀▶ or the <ENTER> button.
z The [ASPECT] individual adjustment screen is
displayed.
3) Press ◀▶ to switch [ASPECT].
z The setting will change as follows each time
you press the button.
[VID AUTO] *1
[S1 AUTO]
[DEFAULT]
[HV FIT]
[V FIT] [H FIT]
*1: Only during VIDEO or S-VIDEO (NTSC) input.
*2: Only during S-VIDEO (NTSC) input.
■ [DEFAULT]
Pictures are displayed without changing the aspect
ratio of the input signals.
■ [VID AUTO]
The projector identifies the video ID (VID) embedded
in the picture signals and displays the picture by
automatically switching the screen sizes between 4:3
and 16:9. This function is effective for NTSC signals.
■ [S1 AUTO]
The projector identifies the S1 signal and displays the
picture by automatically switching the screen sizes
between 4:3 and 16:9. This function is effective for
S-VIDEO NTSC signals.
■ [VID AUTO(PRI.)]
The projector identifies the above mentioned VID or
S1 signals and displays the picture by automatically
choosing the screen sizes of 4:3 or 16:9 according
to the VID if it is detected or S1 signals if a VID is not
detected. This function is effective for S-Video NTSC
signals.
■ [THROUGH]
Pictures are displayed without changing the resolution
of the input signals.
[VID AUTO(PRI.)]
*2 *2
[THROUGH]
[16:9]
[4:3]