Error Information Page - Panasonic PT-DW730ULS Operating Instructions Manual

■ Error information page

When [Error (Detail)] is displayed on the [Projector status] screen, click it to display the error details.
z The projector may go into the standby status to protect the projector depending on the contents of the
error.
zDescription of problem occurrence [FAILED]:
Parameter
[MAIN CPU BUS]
[FAN]
[INTAKE AIR TEMPERATURE]
[OPTICS MODULE TEMPERATURE]
[AROUND LAMP TEMPERATURE]
[LAMP1 REMAIN TIME]
[LAMP2 REMAIN TIME]
[LAMP1 STATUS]
[LAMP2 STATUS]
[SHUTTER]
[INTAKE AIR TEMP.SENSOR]
[OPTICS MODULE TEMP.SENSOR]
[AROUND LAMP TEMP. SENSOR]
[BATTERY]
[AIRFLOW SENSOR]
[COLOR WHEEL]
[COVER OPEN]
[FILTER UNIT]
[AIR FILTER]
There is a problem with the microcomputer circuitry. Consult your
dealer.
There is a problem with the fan or the fan drive circuit. Consult your
dealer.
The air intake temperature is too high. It may be used in an operating
environment where the temperature is high, such as near a heating
appliance.
The temperature inside the projector is high. It may be used in an
operating environment where the temperature is high, such as near a
heating appliance.
The temperature around the lamp is high. The air exhaust port may
be blocked.
The usage time of the lamp has exceeded the specified time, and it is
time to replace the lamp.
The lamp has failed to turn on. Wait a while until the luminous lamp
cools off, and then turn on the power.
There is a problem with the shutter circuitry. Consult your dealer.
There is a problem with the sensor used to detect intake air
temperature. Consult your dealer.
There is a problem with the sensor used to detect temperature inside
the projector. Consult your dealer.
There is a problem with the sensor used to detect exhaust air
temperature. Consult your dealer.
The battery replacement is required. Consult your dealer.
There is a problem with the air volume sensor. Consult your dealer.
There is a problem with the color wheel or the color wheel drive
circuit. Consult your dealer.
The attachment of the lamp unit cover is incomplete. Check the lamp
unit cover. ( page 92)

The air filter unit is not attached. Check the air filter unit. (
There are too much dust accumulated in the air filter unit.
Set the <MAIN POWER> switch (
air filter (  page 89).
[NETWORK] menu
[OK]: Normal operation
[FAILED]: Occurrence of trouble
Description
page 35) to <OFF>, and clean the

ENGLISH - 77
page 90)
