[Text Change]; [Menu Lock]; [Menu Lock Password]; [Control Device Setup] - Panasonic PT-DW730ULS Operating Instructions Manual

Note
z The logo is displayed on the whole screen in
the normal projection condition when [DEFAULT
LOGO] is set. Since the menu screen is displayed,
it is not possible to see the whole image even if the
logo display is canceled by pressing the <MENU>
button.
z Separate software Logo Transfer Software is
required to create and register the pictures of [USER
LOGO]. Refer to the application software download
from the website support information
(http://panasonic.net/avc/projector/software/).

[TEXT CHANGE]

You can change the text displayed when the text display
is enabled by selecting [TEXT] in [DISPLAY SETTING].
1) Press ▲▼ to select [TEXT CHANGE].
2) Press the <ENTER> button.
z The [TEXT CHANGE] screen is displayed.
3) Press ▲▼◀▶ to select the text, and press
the <ENTER> button to enter the text.
z Up to 22 characters can be entered.
4) Press ▲▼◀▶ to select [OK] and
press the <ENTER> button.
z The text is changed.

[MENU LOCK]

You can set to enable/disable the menu operation by
displaying the menu with the <MENU> button.
1) Press ▲▼ to select [MENU LOCK].
2) Press ◀▶ to switch [MENU LOCK].
z The setting will change as follows each time
you press the button.
[OFF]
[OFF] Releases the lock of the menu operation.
[ON] Locks the menu operation.
Note
z The <MENU> button operations will be disabled
when an incorrect password is entered after setting
[MENU LOCK] to [ON].
z The password setting is set to [OFF] at the time of
purchase or when [ALL USER DATA] is initialized.
z The unlock status is maintained until the projector
is set to the standby mode.
You can change the MENU LOCK PASSWORD.
1) Press ▲▼ to select [MENU LOCK
2) Press the <ENTER> button.
3) Press ▲▼◀▶ to select the text, and press
4) Press ▲▼◀▶ to select [OK] and
z The initial password when used for the first time or
z Change the password periodically that is hard to guess.
You can enable/disable the button operations on the
control panel and the remote control.
1) Press ▲▼ to select [CONTROL
2) Press the <ENTER> button.
3) Press ▲▼ to select [CONTROL PANEL]
4) Press the <ENTER> button.
[ON]
■ [CONTROL PANEL]
[SECURITY] menu

[MENU LOCK PASSWORD]

PASSWORD].
z The [MENU LOCK PASSWORD] screen is
displayed.
the <ENTER> button to enter the text.
z Up to 16 characters can be entered.
press the <ENTER> button.
z Select [CANCEL] to stop.
Attention
after initializing all the user data is "AAAA".

[CONTROL DEVICE SETUP]

DEVICE SETUP].
z The [CONTROL DEVICE SETUP] screen is
displayed.
or [REMOTE CONTROLLER].
z The [CONTROL PANEL] or [REMOTE
CONTROLLER] screen is displayed.
z You can set the limitation on the control from
the control panel.
Enables the button operation from
[ENABLE]
the main unit.
Disables the button operation from
[DISABLE]
the main unit.
ENGLISH - 71