Related Manuals for BOCK domiflex
Summary of Contents for BOCK domiflex
- Page 1 Bock Manual – domiflex Tubular Steel Products Interior Furnishings Therapy and Rehabilitation Beds Assembly and Operating Instructions...
-
Page 2: Table Of Contents
Dear Customer, 2. Cleaning, care and disinfection 2.1 Cleaning and care In deciding to buy a therapy and rehabilitation bed from Bock 2.2 Disinfection you have opted for a care product that has a long service life 2.3 Avoiding danger and delivers first class functionality at the highest safety lev- 3. -
Page 3: General Information
At the same time authorised per- sons are given basic training in the functioning and safe hand- ling of the beds. Additional information is given in the Bock security guide, these assembly and operating instructions and in the “Upgrading with Bock”... -
Page 4: Cleaning, Care And Disinfection
All bed ved but first make sure that the defect is eliminated elements can be easily cleaned and looked after with wipe- * Warning note from Bock by the operator or by authorised technicians. and-spray disinfectants that meet the hygiene requirements Never use scouring for the various areas of use. -
Page 5: General Description Of Function
The chassis The telescopic lifting chassis consists of a basic frame whose height is adjusted by two lifting columns. The surface of this steel tubing construction has a heat seated PE powder coa- ting. The side rails Every care bed has two integrated side rails on each side at a height that is designed to guarantee safety. - Page 6 The side rails are primarily intended to stop occupants falling * Warning note from Bock out of bed. – Only use original Bock They may not be sufficient for fragile patients so additional side rails that are avai- protective measures have to be taken, for example by adding lable as accessories for relocatable side rail bumpers (an accessory).
-
Page 7: Caution: Risk Of Injury
3.2 Caution: Risk of injury When the hand control is not in use, make sure it is hung on * Warning note from Bock > Tip from Bock the hook on the bed and cannot fall off. Proper use of all movable parts is essential to guarantee the... -
Page 8: Electric Components
If the maximum adjustment time of two minutes is exceeded, * Warning note from Bock for instance through fiddling with the hand control, and if the Although all Bock care motors overheat, the thermal release will immediately dis- beds are made to a very connect the power supply from the bed. -
Page 9: Lockable Hand Control, Single Fault Safety
Knob positions 3 and 4 are settings for safety controls. Furt- ling function with a corresponding twist of the key. her information on this can be found in the safety guidelines. The new Bock hand control Button 1 Back section up... -
Page 10: Caution: Electrical Drive Unit
4.5 Caution: Electrical drive unit * Warning note from Bock Hermann Bock refers to its electrically operated therapy and Simultaneous use of elec- rehabilitation beds as health beds because they have many trical equipment can, par- functions that help their occupants to recover physically and ticularly in the immediate psychiologically while reducing pain. -
Page 11: Accessories
220 cm. In this way tall persons can lie in comfort and have the same level of functionality. Other special sizes and speci- al functions are available in Bock’s range of special beds as described in the “Bock Works In Special Ways” brochure. -
Page 12: Assembling Accessories
Easy assembly with a clip system is as follows: Side rail bumpers, 1.4 kg (Fig. 3) * Warning note from Bock 1. Remove the mattress from the lying surface. Package: 1 cover, 1 item of bumpers When using accessories 2. Remove the end piece from the foot section. -
Page 13: Mattresses
The domiflex was especially conceived for the demands of as a preprepared checklist x 190 cm, 90 x 200 cm and 100 x 200 cm can be used for Bock daily long-term use in home care. It gives the occupants, fra- in accordance with VDE health beds. -
Page 14: Domiflex In Parts
7.3 domiflex in parts 4. Slide the second end piece only as far as the front of the release button. The Bock domiflex healthcare bed package consists of the fol- lowing parts: Lying surface with motor 1 item Wooden or steel side rail... -
Page 15: Control
Button 5 Lying surface up the hand control must be readily accessible. Button 6 Lying surface down Your domiflex is now ready for use! Knob position 1 Hand control functions active Knob position 2 Hand control functions deactivated Knob positions 3 and 4 are settings for safety controls. Furt-... -
Page 16: Disassembly
7.6 Disassembly tions. Before starting disassembly pull out the mains plug. The domiflex is disassembled in the opposite order to assembly. Key for disabler 7.7 Relocation Note the following safety instructions if the bed has to be relo- cated: –... -
Page 17: Troubleshooting
7.11 Troubleshooting * Warning note from Bock Malfunction Potential causes Remedy This overview indicates malfunctions that you can easily test Never try to fix problems The drive units cannot be Mains cable not connected Connect the mains cable and eliminate yourself, and what malfunctions have to be... -
Page 18: Declaration Of Conformity
Declaration of conformity Manufacturer: Hermann Bock GmbH Nickelstraße 12 D-33415 Verl Product: Care bed domiflex Classification: Medicine products class I, Norm 1 and 12 appendix XI the MDD Selected conformity appraisal procedure: Appendix VII the MDD Hereby we declare that the products specified above fulfil the precautions of the guideline 93/42/EWG of the advice over medicine products. - Page 19 Hermann Bock GmbH Nickelstr. 12 33415 Verl Germany Phone: +49 (0)5246 9205-0 Fax: +49 (0)5246 9205-25 Internet: www.bock.net E-mail: info@bock.net ® registered trademark February 2006 Technical alterations reserved.
Need help?
Do you have a question about the domiflex and is the answer not in the manual?
Questions and answers