Do you have a question about the IM2200DA-UL and is the answer not in the manual?
Questions and answers
Jane M Lang
April 28, 2025
Not making ice.
The green light does not stay solid
1 comments:
Mr. Anderson
May 15, 2025
If the VEVOR IM2200DA-UL ice maker is not making ice and the green light does not stay solid, possible issues include:
1. Low water level or no water in the reservoir. 2. Blocked water screen at the bottom of the reservoir. 3. Pump malfunction. 4. Water inlet not connected to an external water source or the external water source is closed.
Solutions: - Refill water and press the button to restart the ice-making cycle. - Clean the water screen. - If pump malfunction is suspected, send to authorized service. - Check and ensure the external water source is properly connected and open.
Page 1
Technical Support and E-Warranty Certificate www.vevor.com/support ICE MAKER INSTRUCTION MANUAL MODEL: IM2200DA-UL We continue to be committed to provide you tools with competitive price. "Save Half", "Half Price" or any other similar expressions used by us only represents an estimate of savings you might benefit from buying certain tools with us compared to the major top brands and doses not necessarily mean to cover all categories of tools offered by us.
Page 2
CustomerService@vevor.com This is the original instruction, please read all manual instructions carefully before operating. VEVOR reserves a clear interpretation of our user manual. The appearance of the product shall be subject to the product you received. Please forgive us that we won't inform you again if there are any technology or software updates on our product.
Page 3
Read this manual thoroughly before using and save it for future reference. IMPORTANT SAFETY INSTRUCTIONS To reduce the risk of fire, explosion, electric shock, or injury when using your ice maker, follow these important safety instructions: 1.Before using, check that the voltage power corresponds to the one shown on the appliance nameplate.
Page 4
11.Place power cord in such a way that it is not in contact with hot surfaces. 12.The use of attachment not recommended or sold by manufacturer may cause fire, electric shock or injury. 13.Do not touch the evaporator when using the ice maker or making ice to avoid frostbite.
Page 5
32.Do not use the appliance for other than intended use. 33.Please abandon the ice maker according to local regulators as it uses flammable blowing gas and refrigerant. 34.Please dispose of the appliance for its flammable refrigerant and blowing gas according to local regulations. 35.WARNING: Keep ventilation openings in the appliance enclosure or the built-in structure clear of obstruction.
(Product may be subject to change without prior notice) CONTROL PANEL Key (with Function indicator) The indicator lights in green when select large ice. The indicator lights in green when select small ice. - 5 -...
“CLEAN” indicator lights up when the appliance is cleaned Start or stop the appliance Select the ice size The indicator lights in green when making ice. The indicator lights in red when the water reservoir is lack of water. The indicator lights in red when the ice basket is full. BEFORE FIRST USE 1.Unpack the appliance, then check and make sure that all the accessories, including the ice basket and ice scoop, etc., are complete.
4.The appliance must be placed on a dry and level surface with sufficient ventilation, far from heat sources such as ovens, heaters and corrosive gases. Leave about a 6-inch (15cm) clearance on all sides of the ice maker for proper ventilation.
Once this has completed, the ice tray will tilt backwards and the remaining water in the ice tray is drained back into the water reservoir. The ice cubes are then dropped from the evaporator and pushed forward into the ice basket by the ice shovel.
Page 10
To keep your ice tasting fresh and your ice maker looking great, we recommend cleaning your ice maker at least once per week. 1.Stop the ice-making cycle by pressing the“ ”key, unplug the ice maker from the wall outlet and allow it to warm up to room temperature. 2.If residual water is found in the ice tray, gently push the ice tray back so that all water drains into the water reservoir.
TROUBLESHOOTING Problem Possible causes Solution 1.Low water level or lack of 1. Stop making ice, refill water water 2.The water screen at the and then press “ ” bottom of water reservoir is key to restart ice-making cycle. blocked. 2. Do cleaning. 3.Pump malfunction.
Page 13
Please remove the ice if the ice shovel is blocked by ice, The ice shovel is blocked. otherwise, call customer service indicator for consultation. blinks 1. Remove the ice in the ice tray and press the “ ” key to restart The ice maker The ice tray is not in the stops working.
1.Operate the ice maker at a is too high. environment with an ambient temperature between 10℃ and 32℃. TECHNICAL PARAMETERS Model: IM2200DA-UL Ice Production: 33 Ibs/day Applicable climate: ST/SN/N/T Class: I Electrical Rating: AMP 1.8A 120V AC 60HZ - 13 -...
Page 15
Rated power: 130W Refrigerant/Refrigerant amount: R600a/25g Foaming agent: C5H10 Net weight: 11Kg Housing: SUS430 Unit size(WXDXH): L 400×W 246×H 430mm - 14 -...
Page 16
Technical Support and E-Warranty Certificate www.vevor.com/support...
Need help?
Do you have a question about the IM2200DA-UL and is the answer not in the manual?
Questions and answers
Not making ice. The green light does not stay solid
If the VEVOR IM2200DA-UL ice maker is not making ice and the green light does not stay solid, possible issues include:
1. Low water level or no water in the reservoir.
2. Blocked water screen at the bottom of the reservoir.
3. Pump malfunction.
4. Water inlet not connected to an external water source or the external water source is closed.
Solutions:
- Refill water and press the button to restart the ice-making cycle.
- Clean the water screen.
- If pump malfunction is suspected, send to authorized service.
- Check and ensure the external water source is properly connected and open.
This answer is automatically generated