Olympus IR-300 Advanced Manual page 151

Possible cause
The colors of pictures look unnatural.
Indoor lighting affected
the picture's colors.
No white in the picture.
The white balance
setting is wrong.
Part of the picture is dark.
The lens was partly
blocked by your finger or
the strap.
Pictures you have taken do not appear on the monitor.
The power is off.
The camera is in the
shooting mode.
There are no pictures in
the internal memory or
on the card.
There is a problem with
the card.
The camera is
connected to a TV.
Single-frame erase and all-frame erase cannot be performed.
The pictures are
protected.
No picture is displayed on the TV when connected to the camera.
The video output signal
is incorrect.
The TV video signal
setting is incorrect.
The monitor is hard to see.
The brightness of the
monitor is not adjusted
properly.
The monitor is exposed
to direct sunlight.
Corrective action
Set the white balance according to the
lighting.
Include something white in the picture, or
shoot using [#].
Adjust the white balance according to the
light source.
Hold the camera correctly, keeping your
fingers and the strap away from the lens.
Set the mode switch to q, then press the
POWER switch to turn the camera on.
Set the mode switch to q.
[NO PICTURE] is displayed on the monitor.
Record pictures.
See "Error messages".
The monitor does not function when the AV
cable is connected to the camera.
Cancel the protection of the pictures.
Set the video output signal according to the
region where used.
Set the TV to the video input mode.
Use [s] to adjust monitor brightness.
Block the sunlight with your hand.
Troubleshooting
Ref.
page
P. 46
P. 38
P. 46
–
P. 10
P. 10
–
P. 145
P. 76
P. 77
P. 77
–
P. 100
–
151
12