Olympus CAMEDIA C-5060 Wide Zoom Reference Manual page 231

Troubleshooting
Possible cause
The picture is too dark.
The flash was
blocked by your
finger.
The subject was out
of the working range
of the flash.
The flash was set to
the flash off mode.
The subject was too
small and was
backlit.
The sequential
shooting mode was
used.
The center of the
subject is too bright.
The aperture value
setting is too low in A
(M) mode.
The shutter speed
setting is too fast in S
(M) mode.
The colors of pictures look unnatural.
Indoor lighting can
affect the picture's
colors.
No white in the
picture.
The white balance
setting is wrong.
11
Filter was used.
230
Corrective action
Hold the camera correctly, keeping your fingers
away from the flash.
Shoot within the flash working range.
Select a flash mode other than flash off.
Set the flash to fill-in mode, or use the spot
metering mode.
Higher shutter speeds are used when the
sequential shooting mode is selected, which may
result in pictures that are darker than usual.
Select o in the DRIVE menu.
If the center of the subject is too bright, the image
as a whole emerges darker. Adjust the exposure
compensation toward plus (+).
Decrease the aperture value or set the camera to
P mode.
Decrease the shutter speed or set the camera to
P mode.
Set the white balance according to the lighting.
Include something white in the picture, or shoot
using the fill-in flash mode.
Adjust the white balance according to the light
source.
The image may be discolored according to the
filter used. Use the one-touch white balance
function.
Ref. Page
P.41
P.75
P.74
P.74, 97
P.108
P.126
P.86
P.87
P.128
P.74
P.128
P.128