Olympus CAMEDIA C-5060 Wide Zoom Quick Start Manual

1AG6P1P1756

QuickStart Guide

C-5060 Wide Zoom
START HERE
It is strongly recommended that you follow these step-by-step
numbered instructions to set up and quickly begin using your
new Digital camera.
For more detailed instructions on advanced features, please refer to
the printed Basic Manual included in your package, or the Reference
Manual on the CD-ROM.

PREPARING THE CAMERA FOR USE

Before you begin using your Olympus Digital camera...
a.
Charging the battery
• The battery is not fully charged when purchased. Before use, be sure to
charge the battery with the specified provided charger (BCM-2).
Hold the battery with its terminals facing the charger and align the battery
with the guideline on the charger as shown in the illustration. Slide the
battery into the charger.
b.
Loading the battery
Note: The battery and xD-Picture Card compartments are
accessed by opening the respective compartment covers.
• Slide the battery compartment lock from = to ).
• Lift open the cover.
• Insert the BLM-1 lithium ion battery into the compartment as indicated
in the illustration here.
• Close the battery compartment cover and slide the battery
compartment lock from ) to =.
• To remove the battery, make sure that the power switch is aligned to
the OFF position and the camera is turned off (the monitor is off and
the lens is not extended).
• The lock secures the battery when correctly loaded.
TURNING ON THE
CAMERA
The camera Mode dial is used to select the various
operation modes.
a.
Turning the camera ON
(SHOOTING MODE)
• Remove the lens cap.
• Pull the monitor out and rotate it.
• Align P with the red line. Turn the power switch to ON.
The lens extends and the monitor turns on.
• To turn the camera off, turn the power switch to OFF.
Red line
Mode dial
TIP
:To maximize battery life, the Digital camera features a
power saving mode in which the camera enters a sleep
mode after approximately three (3) minutes of non-use.
b.
Setting the Date and Time
Set the date and time before using the camera for the
first time. This affects the way image file names are
created, and will conveniently include this information
with each picture.
• Set the mode dial to P and turn the power switch to ON.
• Press e. The top menu is displayed.
• Press d on the arrow pad to select MODE MENU.
• Press ac to select the SETUP tab, then press d.
• Press ac to select X, then press d.
• Use ac to select the date format.
• Adjust the date and time in the appropriate fields by using
d to select the field, and ac to set the proper value.
Repeat this step until all date/time fields have been set.
Note: Time is entered using the 24-hour
format.
e
• Press twice to set the date and time and exit the
menu.
VT620902
OLYMPUS AMERICA INC.
Two Corporate Center Drive, Melville,
NY 11747-3157, U.S.A.
http://www.olympusamerica.com/support
The following items are also included in the Digital camera package: Basic Manual, AV cable, RM-2 remote control, lens cap & string,
warranty card, registration card (not provided in some areas), and safety precautions booklet.
Battery
compartment
lock
c.
Camera Diagram and Controls
Now take a moment to familiarize yourself with the key areas of camera controls by reviewing the illustrations.
Power switch
Card cover
(OPTIONAL)
Camera Settings In Shooting Mode as shown in Monitor
Shooting mode
Battery check
Green lamp
Flash stand-by
Macro mode
Noise reduction
Flash mode
Flash intensity control
Self-timer/Remote control
Sound record
Record mode

UNPACKING THE BOX CONTENTS

Gather your Digital camera and the parts as shown in the illustration. You'll need these to complete the steps for the camera
set-up procedures that follow.
Digital camera Strap
BCM-2 Lithium ion battery charger
c.
Inserting the xD-Picture Card
The xD-Picture Card is where the camera stores your pictures and is
available in a variety of memory capacities. The pictures you take with
the camera remain on the xD-Picture Card even when the camera is
turned off and/or the battery is removed.
• Open the card cover.
• Face the card the correct way and insert it into the rear card slot as
shown in the illustration. Push the card fully into the slot. The card will
lock into place when fully inserted.
• Close the card cover securely.
Confirm you have installed the battery and xD-Picture Card properly by setting the mode dial
to q and turning the power switch to ON. The "No Picture" message should be displayed in
the monitor. Turn the camera off by turning the power switch to OFF position.
Note: To remove, push the card all the way in to unlock it, then let it return slowly.
d.
Battery
Attaching the strap and lens cap string
compartment
cover
Attach the lens cap string and strap to the strap eyelets on each side of the camera as
illustrated. Attaching the strap to the camera makes it easier to handle.
Strap eyelet
Mode dial
Self-timer/Remote control button
Rotation button
Metering button
Protect button
AF/Macro/
MF button
Hot shoe
Control panel
Shutter button
Zoom lever
Custom button
Print button
Exposure compensation
Shutter speed
Exposure differential
Aperture value
AE lock
AE memory
Metering mode
ISO
White balance
White balance
adjustment
Saturation
Sharpness
Contrast
Drive
Scene modes
Memory gauge
Card
Number of storable
still pictures
Resolution
AF target mark
Metering target mark
Olympus Europa GmbH
Wendenstrasse 14-18,
20097 Hamburg, Germany
http://www.olympus-europa.com
BLM-1 Lithium ion battery CAMEDIA Master
CD-ROM
(OPTIONAL)
Ring
Stopper
Self-timer/
Remote control lamp
Flash
AF illuminator
Remote control receiver
Microphone
AF sensor
Lens
Battery compartment cover
Battery compartment lock
Tripod socket
Camera Settings In Playback Mode as shown in Monitor
Print reservation
Number of prints (Still picture)
Movie (Movie mode)
Card
Battery check
Resolution
Aperture
Shutter speed
http://www.olympus.com/
USB cable xD-Picture
(gray color) Card
Notch
Contact area
A/V OUT jack
USB connector
DC-IN jack
Speaker
Exposure compensation button
Orange lamp
Viewfinder
Diopter adjustment dial
AEL button
Erase button
Power switch
Control dial
QUICK VIEW button
Monitor button
Card access lamp
Card cover
OK/Menu button
Card button
Arrow Pad
Monitor
Green lamp
Flash mode button
Sound record
Protect
Record mode
Exposure compensation
White balance
ISO
Date and time
File number (Still picture)
Playing time/
Total recording time
(Movie mode)
Printed in Japan