Checking Energy-Saving Effect [Carbon Meter] - NEC NP-P350W User Manual

NOTE:
• The [ECO MODE] can be changed by using the menu.
Select [SETUP] → [GENERAL] → [ECO MODE].
• The lamp life remaining and lamp hours used can be checked in [USAGE TIME]. Select [INFO.] → [USAGE TIME].
• The projector is always in [ECO1] ([ECO2])* for 90 seconds after the lamp is turned on and while the POWER indicator is blinking
blue. The lamp condition will not be affected even when [ECO MODE] is changed.
• After a lapse of 1 minute from when the projector displays no-signal guidance, a blue, black or logo screen, [ECO MODE] will
automatically switch to [ECO1] ([ECO2])*. The projector will return to the [OFF] once a signal is accepted.
• If the projector is overheated in [OFF] mode, there may be a case where the [ECO MODE] automatically changes to [ECO1]
([ECO2])* mode to protect the projector. When the projector is in [ECO1] ([ECO2])* mode, the picture brightness decreases.
When the projector comes back to normal temperature, the [ECO MODE] returns to [OFF] mode.
Thermometer symbol [
perature is too high.
* [ECO2] on P350X only

Checking Energy-Saving Effect [CARBON METER]

This feature will show energy-saving effect in terms of CO
is set to [AUTO ECO], [ECO1], or [ECO2]. This feature is called as [CARBON METER].
There are two messages: [TOTAL CARBON SAVINGS] and [CARBON SAVINGS-SESSION]. The [TOTAL CARBON
SAVINGS] message shows the total amount of CO
check the information on [USAGE TIME] from [INFO.] of the menu. (→ page 101)
The [CARBON SAVINGS-SESSION] message shows the amount of CO
changing to ECO MODE immediately after the time of power-on and the time of power-off. The [CARBON SAVINGS-
SESSION] message will be displayed in the [POWER OFF/ ARE YOU SURE ?] message at the time of power-off.
TIP:
• The formula as shown below is used to calculate the amount of CO
Amount of CO emission reduction = (Power consumption in OFF for ECO MODE − Power consumption in AUTO ECO/ECO1/ECO2
2
for ECO MODE) × CO conversion factor.* When the image is turned off with the AV-MUTE button or with the lens cover closed,
2
the amount of CO emmission reduction will also increase.
2
* Calculation for amount of CO
Edition".
• The [TOTAL CARBON SAVINGS] is calculated based on savings recorded in 15 minutes intervals.
• This formula will not apply to the power consumption which is not affected by whether [ECO MODE] is turned on or off.
] indicates the [ECO MODE] is automatically set to [ECO1] ([ECO2])* mode because the internal tem-
emission reduction is based on an OECD publication "CO
2
emission reduction (kg) when the projector's [ECO MODE]
2
emission reduction from the time of shipment up to now. You can
2
emission reduction.
2
29
3. Convenient Features
emission reduction between the time of
2
Emissions from Fuel Combustion, 2008
2