Connect Inlet Hose - Maytag MED6000X Installation Instructions Manual

3.
Tighten couplings
A
Using pliers, tighten the couplings with additional
two-thirds turn.
noTE: Do not overtighten. Damage to the coupling
can result.
4.
Attach long hose to "Y"
connector and tighten couplings
One end of the long hose has a
wire mesh strainer inside the coupling. Attach this end to the
"Y" connector. Attach washer cold inlet hose to other side of
"Y" connector. Screw on coupling by hand until it is seated
on connector. Using pliers, tighten the couplings an additional
two-thirds turn.
noTE: Do not overtighten. Damage to the coupling can result.
16
5.
Attach long hose to dryer fill valve
and tighten coupling
Attach other end of long hose
to fill valve at bottom of dryer
back panel. Screw on coupling
by hand until it is seated on fill valve connector. Using pliers,
tighten the couplings an additional two-thirds turn.
noTE: Do not overtighten. Damage to the coupling can
result.
6.
Turn on cold water faucet
Check that the water faucets are turned on.
7.
check for leaks
Check for leaks around "Y" connector, faucet, and hoses.