Connecting Speakers - Marantz SR5004 User Manual

CONNECTING SPEAKERS

• Be sure to use speakers with the specifi ed impedance as shown on the rear panel of this unit.
• When the subwoofer you are connecting is a powered subwoofer (i.e., has a built-in amp), connect it to
the PRE OUT subwoofer jack.
Powered
FRONT B/HEIGHT
subwoofer
Right
R R L L R R L L R R
FRONT B FRONT B/HEIGHT /HEIGHT FRONT A FRONT A
SW SW
SPEAKER SYSTEMS SPEAKER SYSTEMS
PRE OUT PRE OUT
Right Left
Surround
FRONT A Surround BACK
Left Right Left
Right
L L R R L L
SURROUND SURROUND CENTER CENTER
Center
Notes
• To prevent damage to circuitry, do not let the bare
speaker wires touch each other and do not let them
touch any metal part of this unit.
Left
• Do not touch the speaker terminals when the
power is on. It may cause you to receive an
electric shocks.
• Do not connect more than one speaker cable to
one speaker terminal. Doing so may damage this
unit.
• Be sure to connect the positive and negative
cables for the speaker properly. If they are miss-
connected, the signal phase will be reversed and
the signal quality will be corrupted.
ENGLISH
BASIC CONNECTIONS
CONNECTING SPEAKER WIRE
1.
Strip away approx. 10 mm (3/8 inch) of wire
insulation.
2.
Twist the bared wire ends tight, to prevent
short circuits.
3.
L o o s e n t h e k n o b b y t u r n i n g i t
counterclockwise.
4.
Insert the bare part of the wire into the hole
in side of each terminal.
5.
Tighten the knob by turning it clockwise to
secure the wire.
1. 2.
10 mm (3/8 inch)
3. 4. 5.
11