Connecting Speakers - Marantz SR4023 User Manual

CONNECTING SPEAKERS

ANTENNA ANTENNA
FM ( ( 75 FM 75Ω Ω ) ) GND GND AM AM
DVD DVD DSS DSS AUX AUX VCR VCR MONITOR MONITOR FLASHER FLASHER
IN IN
IN IN IN IN IN IN IN IN OUT OUT OUT OUT
GND GND
VIDEO VIDEO
AUDIO AUDIO AUDIO AUDIO
PHONO PHONO CD CD DVD DVD DSS DSS AUX AUX VCR VCR RECORDER 1 RECORDER 1 RECORDER 2 RECORDER 2
( ( CD-R CD-R) ) ( ( TAPE TAPE) )
L L
R R
IN IN IN IN IN IN IN IN IN IN IN IN OUT OUT IN IN OUT OUT IN IN OUT OUT
Powered
subwoofer
Right Left
System A
AC OUTLETS AC OUTLETS
120V 120V 60Hz 60Hz
UNSWITCHED UNSWITCHED
1.25A 150W 1.25A 150W
RS-232C RS-232C SWITCHED SWITCHED
1.25A 150W 1.25A 150W
AC IN AC IN
R R R R SYSTEM SYSTEM SYSTEM SYSTEM L L L L
A A A A
MODEL NO. SR4023 MODEL NO. SR4023
PRE PRE MAIN MAIN SUB SUB SUB SUB REMOTE CONTROL REMOTE CONTROL
OUT OUT IN IN WOOFER WOOFER WOOFER WOOFER
PRE PRE PRE PRE
OUT OUT OUT OUT
IN IN
OUT OUT
R R R R SYSTEM SYSTEM SYSTEM SYSTEM L L L L
B B B B
SPEAKER SYSTEMS SPEAKER SYSTEMS SPEAKER SYSTEMS SPEAKER SYSTEMS
CLASS 2 WIRING CLASS 2 WIRING CLASS 2 WIRING CLASS 2 WIRING
System B
Right Left
CONNECTING SPEAKER WIRE
1. 2.
10 mm
(3/8inch)
3. 4. 5.
1.
Strip away approx. 10 mm (3/8inch) of wire
insulation.
2.
Twist the bared wire ends tight, to prevent short
circuits.
3.
Loosen the knob by turning it counterclockwise.
4.
Insert the bare part of the wire into the hole in
side of each terminal.
5.
Tighten the knob by turning it clockwise to
secure the wire.
Caution:
• Be sure to use speakers with the specifi ed impedance
as shown on the rear panel of this unit.
• To prevent damage to circuitry, do not let the bare
speaker wires touch each other and do not let them
touch any metal part of this unit.
• Do not touch the speaker terminals when the power
is on. It may cause you to receive an electric shocks.
• Do not connect more than one speaker cable to one
speaker terminal. Doing so may damage this unit.
Note:
Be sure to connect the positive and negative cables for
the speaker properly. If they are miss-connected, the
signal phase will be reversed and the signal quality
will be corrupted.
ENGLISH
CONNECTING A SUBWOOFER
Use the PRE OUT SUBWOOFER jack to connect a
powered subwoofer (power amplifi er built in).
9