Connections; Connecting Speakers - Marantz SR4320 User Manual

CONNECTIONS

CONNECTING SPEAKERS

ANTENNA
GND
PHONO CD CDR / MD
IN IN IN
L
R
Connecting speaker wire
Strip away approx. 3/8 inch (10 mm) of wire insulation.
1
10 mm
2 Twist the exposed wire ends very tight to prevent short circuits.
3 Loosen the knob by turning counterclockwise.
4 Insert one bare wire into the hole in the side of each terminal.
5 Tighten the knob by turning clockwise to secure the wire.
REMOTE
VIDEO
CONTROL
AM
DSS DVD VCR MONITOR
IN IN IN OUT OUT
GND
FM (75 Ω)
TAPE DSS DVD VCR PRE MAIN
OUT IN OUT IN IN IN OUT OUT IN
AUDIO
System B
Right Left
IN
OUT
SPEAKER SYSTEMS
SYSTEM A : 4 -16 OHMS
SYSTEM B : 4 -16 OHMS
SYSTEM A+B : 8 -16 OHMS
SYSTEM B
R L
R L
SYSTEM A
Right Left
System A
CAUTION
• Be sure to use speakers with the specified impedance shown on
the rear panel of this unit.
• To prevent damage to circuitry, do not let
the bare speaker wires touch each other
and do not let them touch any metal part
of this unit.
• Do not touch the speaker terminals when
the power is on. It may cause electric
shocks.
• Do not connect more than one speaker cable to one speaker
terminal. Doing so may damage this unit.
Note:
Be sure to connect the positive and negative cables for the speaker
properly. If they are miss-connected, signal phase will be reversed
and the sound quality will be corrupted.
7
AC IN