MSI MS-9218 User Manual page 76

MS-9218 1U Rackmount Server
ECC Condition
This setting specifies whether ECC Error Condition will be detected.
ECC Error Handler
W hen an ECC error occurs, an interrupt is generated. This setting selects the
type of interrupt to report:
[NMI]
[SMI]
[SCI]
Interleave M ode
This setting determines whether BIOS will auto detect or disable the interleave
mode.
Parallel ATA
This setting enables/disables the onboard PATA controller.
Serial ATA
This setting allows you to enable or disable the onchip Serial-ATA controller.
SATA Controller Mode Option
This setting specifies SATA controller mode. Please note that Pre-W in2K
OS's do not work in Enhanced mode.
[Compatible]
[Enhanced]
(non-AHCI)
MSI Reminds You...
Legacy Mode:
4-8
Non-Maskable Interrupt
System Management Interrupt
System Control Interrupt
SATA and PATA drives are auto-detected and placed
in Legacy mode.
SATA and PATA drives are auto-detected and placed
in Native IDE mode.
* In this mode, system BIOS just assign the traditional 14 and
15 IRQs to use for HDD.
* Older OS's that do not support switch to Native Mode (DOS,
Win2K, Win98/ME...) should set SATA and PATA to Legacy
Mode.
* Maximum 4 ATA devices to connect.
* Combine mode and Non-Combine mode.
- Non-Combined Mode:
- Non-Combined Mode:
- Combined Mode:
P-ATA devices only .
Maximum of 4 devices.
S-ATA devices only.
Maximum of 2 devices.
S-ATA devices
P-ATA devices
Maximum of 2 devices each,
total 4 devices at maximum.