Magtek DynaProx Inspection Manual page 2

DynaProx and DynaProx BCR | Device Inspection
Quick Inspection
As part of your inspection, include the following in the device inspection:
• Be certain to have a list of the devices and include the details listed on
the product label.
• It may be helpful to take photos of the front, back, and side of each device.
Be certain to check device part numbers, serial numbers and IDs and check
physical connections. Use the chart below as a checklist to inspect the
device for signs of tampering.
Site Inspection
Form Factor - check overall form factor
Front
Contactless Landing Zone
Barcode reader (BCR only)
Sides
Form Factor
Right, Left, Top, Bottom edges
Cables
USB-C cable (if applicable)
RS-232 (if applicable)
Underside
Certificate Logos (imprinted)
Form Factor
Cable Connection
Mounting screw insets
Labels
If there is forced entry, the security switches built into the electronics will
be tripped. If they are tripped the sensitive data such as encryption keys
and certificates are cleared as part of security measures mandated by
PCI and the device will not be available to make transactions.
NOTICE:
If the security switches have been tripped, DynaProx and
DynaProx BCR cannot be repaired in the field and must go back to the
factory for repair. Follow RMA procedures. User must report all signs of
tampering as per standard protocol.
MagTek® Inc. | www.magtek.com |
Are there signs of tampering: Signs of tampering
YES
MagTek Inc., 1710 Apollo Court, Seal Beach CA 90740 | p 562-546-6400 | support 562-546-6800 | f 562-546-6301 | www.magtek.com
®
Certifications and Validation
PCI DEVICE VALIDATION
To check for PCI Validation check the Hardware and Firmware ID.
Hardware ID is printed on the label.The Firmware ID is accessible via
the device and displayed on the screen. Go to the PCI compliance web
page and search for MagTek, and find the product name, DynaProx.
Compare the Hardware ID and Firmware ID:
https://www.pcisecuritystandards.org/assessors_and_solutions/pin_transaction_devices
NO TRADEMARKS
EMV® is a registered trademark in the U.S. and other countries and an unregistered trademark
elsewhere. The EMV trademark is owned by EMVCo, LLC. The Contactless Indicator mark,
consisting of four graduating arcs, is a trademark owned by and used with permission of
EMVCo, LLC.
EU STATEMENT
Hereby, MagTek Inc. declares that the radio equipment types Wideband Transmission System (802.11
wireless and Bluetooth Low Energy), and Non-Specific Short Range Device (contactless) are in
compliance with Directive 2014/53/EU. The full text of the EU declarations of conformity is available at
the following internet address:
https://www.magtek.com/Content/DocumentationFiles/D998200505.pdf
UKCA STANDARDS
Hereby, MagTek Inc. declares that the radio equipment types Wideband Transmission System
(Wireless LAN and Bluetooth Low Energy), and Non-Specific Short Range Device (contactless) are in
compliance with Radio Equipment Regulations 2017 Directive S.I.2017:1206. The full text of the UKCA
declarations of conformity is available at the following Internet addresses:
https://www.magtek.com/Content/DocumentationFiles/D998200506.pdf
Registered to ISO 9001:2015 © Copyright 2024 MagTek, Inc. D998200502 rev. 110 10/24