Conroy Qseal-extra Operator's Manual page 19

2.3.2 Battery unit installation and battery charging
Connect as following:
1. Connect the charger to the Battery connector.
2. Plug the charger into a main power supply, the charger LED will light yellow. The
charger can be connected to main voltages between 100 and 240 Volts.
3. Fast charge takes about 3 hours, during chargeing the LED will light orange.
During top-off charge the LED shows green with yellow flash. The battery is fully
charged when the LED shows green (Trickle charge). When the sealer is used for
the first time, or if it has not been used for a while, the battery must be charged
for 24 hours.
We also recommend a 12-hour charge once a month for best performance.
4. Carefully slide the battery into the device, push the battery in completely until
locked in place.
Locking button
To remove the battery, press down the locking button and carefully slide the battery out
of the device.
Caution! Ensure that all parts are connected before turning the power on.
Caution! To prevent possible damage to the device or the battery, never drop the bat-
tery into the device.
CS624 Qseal-extra Operator´s manual 17