Ddr Dimm Module Combination; Installing Ddr Modules - MSI KT6 Delta-FIS2R User Manual

DDR DIMM Module Combination

Install at least one DIMM module on the slots. Memory modules can be
installed on the slots in any order. You can install either single- or double-
sided modules to meet your own needs.
Memory modules can be installed in any combination as follows:
Slot
DIMM 1
(Bank 0 & 1)
DIMM 2
(Bank 2 & 3)
DIMM 3
(Bank 4 & 5)
Maximum System Memory Supported
S: Single Side

Installing DDR Modules

1. The DDR DIMM has only one notch on the center of module. The module
will only fit in the right orientation.
2. Insert the DIMM memory module vertically into the DIMM slot. Then
push it in until the golden finger on the memory module is deeply inserted
in the socket.
MSI Reminds You...
You can barely see the golden finger if the module is properly
inserted in the socket.
3. The plastic clip at each side of the DIMM slot will automatically close.
Memory Module
S/D
S/D
S/D
D: Double Side
Notch
Volt
Hardware Setup
Total Memory
64MB~1GB
64MB~1GB
64MB~1GB
64MB~3GB
2-7