Button Configuration - F&F FW-WS2 Manual

Button configuration

It is possible to change the configuration of the first S1 button to the ON function and
to change the configuration of the second S3 button to the OFF function.
To do this:
①
②
Fold up the buttons.
③
④
Close the buttons and then set up the frame with notch facing up.
Due to the nature of transmission and retransmission it is not recommended to use
the same button on the transmitter more often than every 2 seconds. Switching the
receiver may occur with a slight delay.
It is not recommended to use remote bi-stable transmitters to control a group of
receivers due to the risk of the switching status desynchronization (especially when
working with larger distances and/or simultaneous use of the local buttons on the re-
ceivers).
Remove the frame by prying it gently with a flat tool in the
cut dedicated to this purpose.
Move the switch lever from position S1 to ON (for the first
button) and/or move the switch lever from position S3 to
OFF (for the second button).
- 4 -