Button Configuration; Battery Replacement - F&F FW-WS1 Manual

Button configuration

Due to the nature of transmission and retransmission it is not recommended to use
the same button on the transmitter more often than every 2 seconds. Switching the
receiver may occur with a slight delay.
It is not recommended to use remote bi-stable transmitters to control a group of
receivers due to the risk of the switching status desynchronization (especially when
working with larger distances and/or simultaneous use of the local buttons on the re-
ceivers).

Battery replacement

①
②
Fold up the button.
③
Remove the battery from the holder.
Install a new battery paying close attention to the correct polarity.
④
The "+" sign on the battery up.
⑤
Close the button and then set up the frame with notch facing up.
Do not dispose of the used batteries in the trash! User is obliged to hand over
waste batteries to the collection point for recyclable materials.
Remove the frame by prying it gently with a flat tool in the cut
dedicated to this purpose.
- 4 -