Download Print this page

F&F FW-WS1 Manual

Radio wall switch, 1-button

Advertisement

Quick Links

FW-WS1
Radio wall switch,
1-button
Do not dispose of this device to thrash with other unsorted waste! In accordance
with the Waste Electrical and Electronic Equipment Act any household electro-waste
can be turned in free of charge and in any quan� ty to a collec� on point established for
this purpose, as well as to the store in the event of purchasing new equipment (as per
the old for new rule, regardless of brand). Electro-waste thrown in the trash or aban-
doned in the bosom of nature pose a threat to the environment and human health.
Description of the system
F&Wave is a family of wireless devices controlled by radio with a range of up to 100
meters*. The receivers are available in either a DIN-rail mounting version (housing
1S) or a ø60 flush-mounted version. The transmitters are available as handheld remo-
te controllers or as a flush-mounted version. The receivers relay control signals. The
device that receives a control signal from the transmitter will automatically send it
forward, which allows to increase the range of the remote control.
* Range of up to 100 meters in open space without any interfering factors. In building conditions and in the presence of
interference sources (power lines, transmitters, etc.) the actual range may be smaller.
F&F Filipowski L.P.
Konstantynowska 79/81, 95-200 Pabianice, PL
phone/fax (+48 42) 215 23 83 / (+48 42) 227 09 71
www.fif.com.pl; e-mail: biuro@fif.com.pl
- 1 -

Advertisement

loading

Summary of Contents for F&F FW-WS1

  • Page 1 F&F Filipowski L.P. Konstantynowska 79/81, 95-200 Pabianice, PL phone/fax (+48 42) 215 23 83 / (+48 42) 227 09 71 www.fif.com.pl; e-mail: biuro@fif.com.pl FW-WS1 Radio wall switch, 1-button Do not dispose of this device to thrash with other unsorted waste! In accordance with the Waste Electrical and Electronic Equipment Act any household electro-waste can be turned in free of charge and in any quan�...
  • Page 2: Features Of The Device

    Features of the device 1-button remote control transmitter;  Works with F&Wave remote control receivers;  Ability to control any number of receivers;  ON/OFF (bi-stable switch) with receivers: FW-R1P, FW-R1D, FW-R2P, FW-R2D,  FW-D1P, FW-D1D, FW-LED2P, FW-LED2D; Raise/lower the roller blind with receivers FW-STR1P, FW-STR1D; ...
  • Page 3 Pairing After you successfully connect the receiver, press and hold the PROG button until the device switches ① on the output circuit and the communication LED goes off. ② Press the button. If the pairing is correct, the output circuit will be momentary switched off and ③...
  • Page 4: Button Configuration

    Button configuration Due to the nature of transmission and retransmission it is not recommended to use the same button on the transmitter more often than every 2 seconds. Switching the receiver may occur with a slight delay. It is not recommended to use remote bi-stable transmitters to control a group of receivers due to the risk of the switching status desynchronization (especially when working with larger distances and/or simultaneous use of the local buttons on the re- ceivers).
  • Page 5 Devices of the F&Wave system Battery transmitters Type Product Flood sensor FW-FS1 Remote control FW-KEY, FW-RC4, FW-RC10 FW-WS1, FW-WS2, FW-WS3 Wall button FW-WSO1, FW-WSO2, FW-WSO4 Flush-mounted box ø60 FW-RC5 AC transmitters Type Product FW-GS1, FW-GS2, FW-GS4 Flush-mounted box ø60 FW-RC4-AC...
  • Page 6: Technical Data

    Technical data power supply 3 V DC battery CR2032 battery life approx. 15 hours of broadcasting (pressed button on the switch) radio frequency 868 MHz maximum emitted frequency power 10 mW power consumption button pressed 20 mA standby 15 nA working temperature 5÷50°C dimensions...