MSI 865PE Neo2-P Platinum Edition User Manual page 67

MS-6728 ATX Mainboard
Set Super I/O
Press <Enter> to enter the sub-menu and the following screen appears:
OnBoard F DC
Select Enabled if your system has a floppy disk controller (FDD) installed
on the system board and you wish to use it.
Option
Auto
Enabled
Disabled
Onboard Serial Port A/B
These items specify the base I/O port addresses of the onboard Serial
Port 1 (COM A)/Serial Port 2 (COM B). Selecting Auto allows AMIBIOS
to automatically determine the correct base I/O port address. Settings:
Auto, 3F8/COM1, 2F8/COM2, 3E8/COM3, 2E8/COM4 and Disabled.
Serial Port B Mode
This item sets the operation mode for Serial Port B. Settings: Normal,
1.6uS, 3/16 Baud and ASKIR (the last three operation modes are
setting options for IR function).
IR Duplex Mode
This setting controls the operating mode of IR transmission/
reception. Setting options: Full Duplex, Half Duplex. Under Full
Duplex mode, synchronous, bi-directional transmission/reception
is allowed. Under Half Duplex mode, only asynchronous, bi-
directional transmission/reception is allowed.
3-24
Description
BIOS will automatically determine whether to enable the
onboard Floppy controller or not.
Enables the onboard Floppy controller.
Disables the onboard Floppy controller.