MSI 865PE Neo2-P Platinum Edition User Manual page 50

Primary/Secondary/Third/Fourth IDE Master/Slave
Press PgUp/<+> or PgDn/<-> to select the hard disk drive type. The specification
of hard disk drive will show up on the right hand according to your selection.
Type
Cylinders
Heads
Write Precompensation
Sectors
Maximum Capacity
LBA Mode
Block Mode
Fast Programmed I/O
Modes
32 Bit Transfer Mode
Floppy Drive A:/B:
This item allows you to set the type of floppy drives installed. Available
options: Not Installed, 1.2 MB 5¼ , 720 KB 3½ , 1.44 MB 3½ and 2.88 MB 3½ .
Select how to define the HDD parameters
Enter cylinder number
Enter head number
Enter write precomp cylinder
Enter sector number
Read the maximal HDD capacity
Select Auto for a hard disk > 512 MB un-
der Windows and DOS, or Disabled un-
der Netware and UNIX
Select Auto to enhance the hard disk
performance
Select Auto to enhance hard disk perform-
ance by optimizing the hard disk timing
Enable 32 bit to maximize the IDE hard disk
data transfer rate
BIOS Setup
3-7