Bios Recovery Jumper: J9; Bios Write Protect Jumper: Jbios1; Lan Jumper: Jlandis1, Jlandis2 - MSI 5000V Master-A6 User Manual

BIOS Recovery Jumper: J9

Users can short connect pin#2-3 to recover the system BIOS. W hen the system is
done with the job, the buzzer will beep to remind users to set the jumper to its normal
state (pin#1-2 short connected).
1

BIOS Write Protect Jumper: JBIOS1

A "boot block" program is included as part of the system BIOS to recover the system
from a situation when the BIOS code is incorrect/corrupted or needs to be updated.
W hen the BIOS code is corrupted or needs to be updated, you have to at first disable
the write protect function by shorting 1-2 pin of the JBIOS1 jumper. Then the boot
block will try to recover the BIOS code, usually by reading it from a specially-pre-
pared floppy disk.
Under normal operation, we suggest that you enable the write protect function by
shorting 2-3 pin of the JBIOS1 jumper to protect the boot block from virus infection.
1
JBIOS1

LAN Jumper: JLANDIS1, JLANDIS2

These jumpers control the onboard LAN. The JLANDIS1 disables/enables the LAN1
jack while the JLANDIS2 disables/enables the LAN2 jack.
1
JLANDIS1
1
JLANDIS2
J9
1
Normal
Disable Write Protect
1
Enable LAN1
1
Enable LAN2
Hardware Setup
3 1
Recovery
1 1
3 3
Enable Write Protect
1
Disable LAN1
1
Disable LAN2
3
2-17