Extremis AMAi Manual page 89

9. Now go back to step 5 on page 17 (standard module).
Now go back to step 9 on page 34 (extension module).
10. Next slide the three stainless steel tubes through the rectangular
tubes. Attention: make sure the bracket is facing upwards.
11. Next attach the three stainless steel tubes to the rectangular brackets
using two M8x12 bolts each.
12. Now hang the fabric on the AMAi by sliding it over the three stainless
steel tubes. Make sure the side with the two black cords faces
outwards.
13. Push the fabric all the way up to the top profile and hook the first
stick in the three hooks under the tubes. Tip: When doing so, lift the
shade stopper profile slightly so that the pole can pass through.
14. Use the black cords to open the shade. Clamp the outer pole in the
three black plastic hooks on the outside of the stainless steel tubes to
hold the shade open. When closing the shade, make sure the fabric
goes all the way under the shade stopper profile.
15. Lead one of the bungees of the black cords through the loop to
secure the shade when closed.
89