STARLINK GEN 3 ROUTER MOUNT Installation Manual page 3

INSTALL
NON-ANCHOR INSTALLATION
Mark and Drill Mounting Holes
1 |
Use the mount as a guide to mark the hole
locations, then drill using a 4mm (5/32 in) drill bit
if not using the provided drywall anchors.
2 | Screw Mount to Surface
Secure the Mount using the provided screws.
3 | Route Cables and Plug into Router
Route the power and Starlink cables through the
opening in the mount and plug the cables into the router.
4 | Snap the Router into Mount
Fit the bottom edge of the router into the mount, then
press the router into the mount until it clicks into place.
4 mm (5/32 in)