Download Print this page

Installing Vinyl Siding Standoff - DuraVent DirectVent Pro Installation Instructions Manual

Venting system for direct vent gas stoves and fireplaces
Hide thumbs Also See for DirectVent Pro:

Advertisement

entering the Snorkel Termination
(Fig. 11). Do not attempt to enclose
the Snorkel within the wall or any
other type of enclosure.
VINYL SIDING
INSTALLATION
7KH 9LQ\O 6LGLQJ 6WDQGR SUHYHQWV
excessive heat from potentially warping
or melting the vinyl siding material.
9LQ\O 6LGLQJ 6WDQGR V DUH QRW XVHG ZLWK
6QRUNHOV 7KH 9LQ\O 6LGLQJ 6WDQGR LV
available in either a 1-piece version or a
4-piece version.
,QVWDOOLQJ WKH SLHFH 9LQ\O 6LGLQJ
6WDQGR  Cut a square opening in
the vinyl siding centered around the
framed opening, in accordance with the
dimensions provided in Table 1, page 8.
ƒ 0RXQW WKH 9LQ\O 6LGLQJ 6WDQGR WR WKH
wall using the screws provided.
ƒ Seal around the perimeter of the Vinyl
6LGLQJ 6WDQGR XVLQJ QRQKDUGHQLQJ
waterproof sealant to help ensure a
weather tight seal.
ƒ Secure the Horizontal Termination Cap
WR WKH 9LQ\O 6LGLQJ 6WDQGR XVLQJ WKH 
long screws provided with the cap.
,QVWDOOLQJ WKH SLHFH 9LQ\O 6LGLQJ
6WDQGR  7KH 9LQ\O 6LGLQJ 6WDQGR
should be assembled and installed
on the wall between the Horizontal
TABLE 2
STOCK #
EXTERIOR OPENING
46DVA-VSK
13½" x 13½"
46DVA-CFK
46DVA-VSKS
10½" x 10½"
46DVA-CFKS
58DVA-VSK
16" x 16"
58DVA-CFK
Install 46DVA-VSKS or 46DVA-CFKS for 5" x 8"
DirectVent Pro Sconce or Round Termination Caps
Cap and the building exterior. Cut
a square opening in the vinyl siding
centered around the framed opening,
in accordance with the dimensions
provided in Table 2.
ƒ The 4 pieces of the Vinyl Siding
6WDQGR RU &RXQWHU )ODVKLQJ PXVW
EH DVVHPEOHG LQ VSHFL¿F RUGHU WR KHOS
HQVXUH D ZHDWKHU WLJKW ¿W
ƒ Loosely assemble the four parts,
in order, around the opening in the
YLQ\O VLGLQJ 3ODFH WKH ¿UVW RI  SLHFHV
along the upper edge of the opening in
the vinyl siding. Progressing counter-
clockwise, place the left side, the
bottom side, and then the right side
around the opening in the siding. Refer
to Figure 12.
ƒ With the 4 pieces in place secure the
pieces together using the pre-drilled
holes and the screws provided.
ƒ Seal around the inside corners of the
9LQ\O 6LGLQJ 6WDQGR WR KHOS HQVXUH D
weather tight installation.
ƒ Attach the Horizontal Cap to the
9LQ\O 6LGLQJ 6WDQGR  /LQH XS WKH KROHV
in the cap with the holes in the Vinyl
6LGLQJ 6WDQGR DQG VHFXUH ZLWK WKH 
long screws provided with the cap.
ƒ 6HFXUH WKH 9LQ\O 6LGLQJ 6WDQGR WR
the wall as appropriate. Depending on
WKH FRQVWUXFWLRQ RI \RXU ZDOO GL HUHQW
PHWKRGV RI VHFXULQJ WKH VWDQGR DQG
cap may be required. The Vinyl Siding
Minim
6WDQGR ¶V ÀDQJHV H[WHQG ´ XQGHU WKH
siding and can be secured to the wall
by using screws through the siding
DQG ÀDQJH LI QHHGHG
ƒ Seal around the perimeter of the
9LQ\O 6LGLQJ 6WDQGR XVLQJ QRQ
hardening waterproof sealant to help
11

Advertisement

loading
Need help?

Need help?

Do you have a question about the DirectVent Pro and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Directvent pro 4"x6-5/8"Directvent pro 5"x8"