PURSUIT PR71B Operator's Manual

Rf upgrade kit

Download this manual

Model PR71B

Operators Manual

RF Upgrade Kit

Start Button

Press two times in

succession to

start vehicle

To Operate System:

1) Press transmitter button two times in succession to start the vehicle. The vehicle will start and

run the predetermined time set up during installation (5 to 60 minutes selectable).

2) During the run cycle, enter the vehicle using your door key or, if the unlock option is installed,

once you are within range of the vehicle, press and hold the transmitter button for 3 seconds to

unlock the vehicle doors.

3) Enter the vehicle, insert your key and turn it to the run, NOT START, position, then step on the

brake, the vehicle is now in control of the ignition key.

NOTE: For push to start vehicle systems, contact your installation center for proper procedure.

4) With vehicle running, if you wish to make a quick stop and leave the vehicle running, once you

arrive at your destination:

a) place the gear selector in Park,

b) set the parking brake,

c) with your foot off the brake, press the transmitter button two times in succession.

The vehicle will now be under control of the remote start system. Turn your ignition switch off,

WITHOUT, stepping on the brake, and exit the vehicle. Lock the doors with the key to insure

security.

PATENTED: www.voxxintl.com/company/patents

128-9478

Page 1

Need help?

Do you have a question about the PR71B and is the answer not in the manual?

Page 1 Model PR71B Operators Manual RF Upgrade Kit Start Button Press two times in succession to start vehicle To Operate System: 1) Press transmitter button two times in succession to start the vehicle. The vehicle will start and run the predetermined time set up during installation (5 to 60 minutes selectable).
Page 2 TIMED START PROGRAM: The Remote Start unit has the ability to start the vehicle automatically at timed intervals. This feature is useful in extremely cold climates where starting the engine is the only means to keep the battery charged and fluids warm. The operator has the option to have the unit start every 2 or 4 hours for a maximum of 48 hours.
Page 3 Programming New or Replacement 171BPR Transmitters: 1) Turn the ignition switch to the “On” position” 2) Press and release the pushbutton switch found on the windshield mount receiver 3 times. (The LED on the receiver will flash). 3) Press and hold the transmitter start button, until the LED on the receiver turns solid. 4) Release the transmitter button.
Page 4 To purchase replacement transmitters or to get additional product information go to: www.pursuitcarsecurity.com FCC COMPLIANCE This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.