PURSUIT PR1BTW Operator's Manual

Model PR1BTW
Operators Manual
RF Upgrade Kit
Start Button
Press two times in
succession to
start vehicle
To Operate System:
1) Press transmitter button two times in succession to start the vehicle. The vehicle will start and
run the predetermined time set up during installation (5 to 60 minutes selectable). The two way
transmitter will flash every 10 seconds during the run cycle to advise you that the vehicle started
and is running.
2) During the run cycle, enter the vehicle using your door key or, if the unlock option is installed,
once you are within range of the vehicle, press and hold the transmitter button for 3 seconds to
unlock the vehicle doors.
3) Enter the vehicle, insert your key and turn it to the run, NOT START, position, then step on the
brake, the vehicle is now in control of the ignition key.
NOTE: For push to start vehicle systems, simply enter the vehicle with your key in hand, and
step on the brake.
4) With vehicle running, if you wish to make a quick stop and leave the vehicle running, once
you arrive at your destination:
a) place the gear selector in Park,
b) set the parking brake,
c) with your foot off the brake, press the transmitter button two times in succession.
The vehicle will now be under control of the remote start system. Turn your ignition switch off,
WITHOUT, stepping on the brake, and exit the vehicle. Lock the doors with the key to insure
security.
TIMED START PROGRAM:
The Remote Start unit has the ability to start the vehicle automatically at timed intervals. This
feature is useful in extremely cold climates where starting the engine is the only means to keep
PATENTED: www.voxxintl.com/company/patents
128-9454
Page 1