Connection to External Equipment
Cable or VHF/UHF (or VHF only)
Connecting a cable system or an external VHF/UHF antenna to the VHF/UHF input will allow you to
enjoy high definition and standard definition digital programming (if available in your area) along with
the standard definition analog programming.
75-ohm coaxial
cable (supplied)
Cable and VHF/UHF (or VHF only)
If you want to watch both cable and antenna (over-the-air) programming, you will need to use an
optional A-B RF Switch (not supplied) to switch between the cable and over-the air antenna
programming, as shown.
Cable
Antenna
Cable TV Connections
- After subscribing to a local cable TV service, you can watch cable TV programming.
- Depending upon the cable provider, a cable box may be necessary.
- For further cable TV information, contact a local cable service provider.
Connection
1. Set cable box switch to 3 or 4 and then tune TV to the same channel number.
2. Select VIDEO source input to use Audio/Video In connections.
3. Select channels with the cable box.
A/B RF Switch
Cable Box Connection Panel
TV
VCR
Rear of TV
ANT
(R) AUDIO (L)
VIDEO
RF
Cable
Rear of TV
11