LG LRM-519 User Manual page 72

Issue
Channels do not change
with the serial data control
cable connected.
The message "<TV show>
cannot be recorded
because there are too
many recorded shows"
appears.
Pictures and Music from
other computers are not
available.
Cannot record a DVD
from a DVD player to the
Recorder.
The Recorder plays a
sample video repeatedly.
72
Solution
Restart both the satellite set-top box and the Recorder. If this channels
still do not change, use the IR control cable instead.
Notes:
• Some satellite set-top boxes support the use of the serial data
control cable to change channels and the IR control cable. However,
not all of theses specific satellite set-top boxes enable the serial input
port. For more information, check with the set-top box manufacturer.
• Before you connect the serial data control cable, make sure the
power cord for the Recorder and the power cord for the satellite
setBefore you connect the serial data control cable, make sure the
power cord for the Recorder and the power cord for the satellite set-
top box are not plugged into a power outlet or power strip.
• The Recorder supports serial data control by using the Serial-APG
and Serial-MPG serial data control protocols. Check with the set-top
box manufacturer or satellite service provider to make sure your
satellite set-top box uses this standard.
For more information, see The IR control cable and the Serial Data
Control Cable.
The Recorder disk drive contains too many recorded TV shows and
there is not enough disk space to record the current show. Go to
Recorded TV and delete some recorded shows, or add a USB device for
additional storage. For information about adding a USB device, see Add
Additional Storage.
To display pictures and play music stored on a computer, the computer
and the Recorder must be connected to the same network and the
computer must be running Window Media Connect.
If these two conditions are met, check the following:
• Make sure both the computer and the Recorder have network access.
For example, try downloading the Guide listings on the Recorder and
open a browser window on the computer.
• The computer must be turned on.
• Open Windows Media Connect and make sure the Recorder is listed
®
as a recognized device.
For more information, see Windows
and Music Stored on a Computer.
You cannot connect a DVD player and then copy a DVD to the
Recorder. For more information, see Copying of Commercial/Retail
Copyrighted DVDs.
The Recorder may be in Demonstration mode. To end Demonstration
mode, unplug the power cord from the back of the Recorder, wait five
seconds, and then re-attach the power cord to the Recorder while press
OPEN/CLOSE on the front panel.
Media Connect: Access Pictures
®