Saxby Lighting Atlantis Post Instruction Leaflet

Commissioning
- Refer to Fig. 1. Fit the product over the fixing bolts,
re-fit the plastic washers (B) and then the dome nuts
(A). Use a suitable spanner to securely tighten the
product to the mounting surface.
Fitting/replacing bulb (Max. 7W LED GU10)
When changing a bulb, always switch off at the mains
and allow the bulb to cool before handling. Dispose of
used bulbs carefully. Use a soft cloth to handle bulbs,
avoid directly touching the bulbs as this will shorten their
life. Do not exceed the wattage stated or use a different
shape bulb from that indicated on the fitting.
Check with your retailer re bulb dimming capability before
purchasing replacement bulbs.
Care & Cleaning
Do not use solvents or abrasive cleaners as these could
damage the finish.
In some cases, surface corrosion may arise after
installation. This is normally caused by tiny iron particles
left behind after the brushing process when finishing.
In normal circumstances, stainless steel is very resistant
to corrosion. It does however require maintenance to
preserve the high quality appearance. Wash the product
with warm soapy water, removing all surface deposits.
Rinse with clean water and with a soft cloth, wipe dry.
Then with a soft cloth soaked with a protective oil, wipe
all over.
Recycling advice
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Safety information
For your safety, always switch off the power supply before changing lightbulbs, or cleaning. Live Voltages may be
present in this unit even when turned of or when completely disconnected. This system contains non-replaceable
parts and cannot be serviced. If damage occurs, the part should be scrapped.
The shade must be replaced immediately should the shade become cracked or damaged. This fitting
must not be used without the shade in place.
Replace Cracked Shade
UK Manufacturer: BH17 7BY
EU Manufacturer: Brilliant AG,
Brilliantstrasse 1, D-27442 Gnarrenburg
www.saxbylighting.com
- Replace fuse or circuit breaker and switch on. Your
light is now ready for use.
1. Unscrew the bezel
7W LED GU10
2. Remove the old bulb
by turning anti-clockwise.
3. Insert new bulb.
4 Replace the bezel
ensuring that it is
tightly secured.
If the product is subject to extreme environmental
conditions such as marine locations, industrial pollution
and acid rain these maintenance procedures should
be carried out around four times a year. For severe
corrosion, non-abrasive cream cleaners or proprietary
stainless steel cleaners should be used to remove the
corrosion. Wash and dry as detailed above. Then with a
soft cloth soaked with a protective oil, wipe all over.
Glass parts: Remove and wash in warm water or just
use a damp cloth. Do not use abrasive materials as
these will damage the finish.
V7 08/04/2022
Saxby Lighting
Instruction leaflet
Atlantis Post
70847, 70848
70848
70847