gCreate gMax 2 Getting Started page 9

Leveling X-Axis Arm
The gMax 2 has a new method for leveling the X-Axis arm. The X-axis arm should be leveled using this method
prior to any bed leveling.
1. To level the X-Axis arm go to
2. The printer will home to the center, and the extruder will move to the right side.
3. The printer will then lower un l the extruder hotend is below the bed and the X-axis arm will bump
against the metal side plates. This will ensure the printer always has the same baseline when
star ng a print and the bed leveling will handle the rest.
Level
Point
4. If the arm doesn't look level, run the rou ne again.
5. Run bed leveling. Go to
"gMax Tools > Level
"Prepare > Level Bed".
X-Axis".
Pg 8